Pioneer DDJ-RB Service Manual page 33

5
2-2: Photo interrupter check mode
This mode is to check the status of Photo interrupter.
When the measurement mode starts, FX1 ON of the right DECK will light up.
Operation procedures
1. Spin the Jog dial swiftly.
To start measurement, the maximum Jog rotation speed must be 10 times normal speed or higher.
If the maximum speed does not reach 10 times normal speed, no result will be displayed.
2. The number of sessions will be displayed up to four sessions on LED as follows.
The end of 1st session
The end of 2nd session
The end of 3rd session
The end of 4th session
After the end of 4th session
3. If the measurement result is OK, [AUTO] LED is turned on.
If the measurement is failed, [TAP] LED is turned on.
Clockwise
JOG Pulse
P1
JOG Pulse
P2
Counter clockwise
JOG Pulse
P1
JOG Pulse
P2
Time A - D will be memorized in each range of the speed: x21~x19/ x16~x14/ x11~x9/ x6~x4.
OK When phase relation is normal, and the minimum value of all the A -D is 10 usec or greater, -----[AUTO] lighting
and the time of [x11~x9] (clockwise: "D"; counterclockwise: "C") is 200 usec or greater.
NG When none of these conditions described above is not satisfied.
5
6
HOT CUE lighting
PAD FX1 lighting
SLICER lighting
SAMPLER lighting
remain unchaged
DDJ-RB
6
7
------[TAP] lighting
7
8
A
B
C
D
E
F
33
8