CONGRATULATIONS ON THE PURCHASE OF YOUR NEW ACN DIGITALTALK® EXPRESS PHONE SYSTEM!
Before you begin the installation process, please confirm you have the following:
STOP
1.
An active Internet connection
2.
All devices associated with your new phone system
ACN Installation Instructions email (Required for telephone number registration and configuration (see page 2))
3.
Once confirmed you have the items noted above, please review then follow the instructions in sequence below, beginning with Step 1.
It is important to note that the initial setup process and registration of your devices can take up to 1 hour. Please ensure that you have
completed the process to charge your handset (if applicable) prior to beginning the installation process.
REVIEW ITEMS INCLUDED WITH YOUR PHONE SYSTEM
Depending on the equipment ordered, you will have the following items included in your shipment:
Wireless Base Station
(KX-TGP600)
AC Adaptor for Base
Ethernet Cable (1)
Station (1)
DC Output: 6.5 V
STEP 1 A – SETTING UP THE HANDSET(S) CHARGER / PREPARING THE HANDSET(S) FOR USE
1. Open the battery cover, insert the
batteries and close the cover.
2. Connect the AC adaptor to the charger.
Handset
3. Place handset in charger for at least
six (6) hours prior to registration/use.
Desktop Phone
AC Adaptor for Desktop
Phone (1)
(KX-TPA65)
DC Output: 6.5 V
Screws & Washers for
Desktop Wall Mount (2/2)
Bottom of Handset charger
PANASONIC PHONE SYSTEM INSTALLATION GUIDE
Model numbers: KX-TGP600, KX-TPA60, KX-TPA65
Desktop
Handset (1)
Desktop
Desktop
Handset Cord (1)
Stand (1)
STEP 1 B – ASSEMBLING THE DESKTOP PHONE(S)
Desktop Phone
Attach the AC adaptor, corded handset (and headset, where applicable) to the desktop phone.
AC Adaptor for
Handset Phone
Handset Charger (1)
(KX-TPA60)
DC Output: 5.5 V
Handset
Handset
Belt Clip (1)
Batteries (2)
Bottom of Desktop Phone