Displays - Silvercrest SLE 450 A1 Operating Instructions Manual

__CPE111670_B6.book Seite 8 Mittwoch, 11. März 2015 12:51 12
Air outlet flap valve
• Figure A: irrespective of which mode
the device is being operated in, open
the top flap valve 1. It's infinitely adjust-
able. If the flap valve is not opened, the
overheating protection will switch the
device off after a while for approx.
3|minutes.

7.2 Displays

The mode of operation LEDs 16 and the dis-
play 15 show the selected functions and the
humidity range.
Mode of operation LEDs
LED illuminated
The water tank is
TANK FULL full or has not been
inserted.
A switch-off time is
TIMER
activated.
AIR CLEAN
DRY CLOTHES
Selected mode
TARGET-HUMIDITY
AUTOMATIC
The device is
OPERATION
switched on.
8
GB
Display
Display
Meaning
LC
1 - 24
flash for 5 sec.
30 - 80 or CO
flash for 5 sec.
Meaning
This display can be seen
continuously during oper-
ation. It shows the humid-
ity range in the room:
HIGH
MID.
LOW:
LOW
under 65%
MID:
HIGH
MID.
65% to 75%
LOW
HIGH:
over 75%
HIGH
MID.
NOTE: this display is not
LOW
visible if the child safety
lock is activated.
The child safety lock is
activated. The device
cannot be operated by
using the buttons.
Timer for all modes:
These values (1 - 24 hours)
will flash for 5 seconds
when you use the arrow
keys to select a switch-off
time.
Enter relative humidity as
target humidity.
Values between 30 and
80 or CO will flash for
5|seconds when
selected.
CO: The device dehu-
midifies continuously.