LG 32LC2D User Manual page 37

9U0569A-1 Rev05 1/9/96
Screen Setup for PC mode
Overview
This function works in the following mode:
Component1, Component2, RGB-PC, RGB-DTV, or HDMI/DVI.
Note: Some signal from some graphics boards may not function properly. If the results are unsatisfactory, adjust
your monitor's position, size and phase manually.
Adjustment for screen Position, Clock, Phase
Press the O O K K
1
P P o o s s i i t t i i o o n n , C C l l o o c c k k , or P P h h a a s s e e .
Press the
G G
2
make appropriate adjustments.
The P P h h a a s s e e adjustment range is - - 3 3 2 2
I
The P P h h a a s s e e only works in Component 1-2, RGB-PC and
RGB-DTV mode.
The C C l l o o c c k k adjustment range is - - 5 5 0 0
I
The C C l l o o c c k k only works in RGB-PC mode.
3
Press the O O K K
Initializing (Reset to original factory values)
To initialize the adjusted values
This function allows you to return to the good picture repro-
duction programmed at the factory and cannot be change.
Press the O O K K
1
R R e e s s e e t t .
Press the
G G
2
Y Y e e s s .
Press the O O K K
3
2:52 PM Page 33
button and then use or
D D
button and then use
D D E E F F G G
~
+ + 5 5 0 0 .
~
button.
button and then use or
D D
button and then use or
F F G G
button.
button to select
E E
button to
+ + 3 3 2 2 .
P P o o s s i i t t i i o o n n This function is to adjust picture
C C l l o o c c k k
P P h h a a s s e e
button to select
E E
button to select
G G
Position
Clcok
D D
Phase
F F G G
E E
Reset
Close
1
to left/right and up/down as you
prefer.
This function is to minimize any
vertical bars or stripes visible on
the screen background. And the
horizontal screen size will also
change.
This function allows you to
remove any horizontal noise and
clear or sharpen the image of char-
acters. In HDMI/DVI-PC mode,
PHASE is not available.
Position
Clcok
Initialize Settings
Phase
G G
Reset
Close
1
2 3
2 3
33