Watching Tv; Preparation; Turning On The Power; Select The Tv Mode - Sharp Aquos LC 20DV20U Operation Manual

Watching TV

Simple operations for watching a TV program
MENU VOL +/ – CH
POWER
TV/DVD status indicator (POWER)
ON
OFF/Standby

Preparation

Perform the following steps before you press POWER
on the remote control unit.
1. Insert the batteries into the remote control unit.
(See page 8.)
2. Connect the antenna cable to the TV/DVD. (See page
12.)
3. Plug in the AC cord to the AC outlet. (See page 7.)

Turning on the power

Press POWER on the TV/DVD, or POWER on the
remote control.
• POWER indicator (Green): The TV/DVD is on.

Select the TV mode

Press TV/DVD to select the TV mode.
NOTE
• The LANGUAGE setup menu will appear automatically
when TV MENU is pressed on for the fi rst time.
/
POWER indicator
Lighting (Green)
Lighting (Red)

Turning off the power

Press POWER on the TV/DVD, or POWER on the
remote control.
• The TV enters standby mode and the image on the
screen disappears.
• The POWER indicator on the TV/DVD changes to Red.
NOTE
• If you are not going to use this TV/DVD for a long period
of time, be sure to remove the AC cord from the power
outlet.
• Weak electric power is still consumed even when
POWER is turned off.
• If a station being viewed stops broadcasting, the TV will
automatically shut itself off after 15 minutes.

Changing channels

You can change channels in several ways.
Method 1
Using CH / on the remote control unit or on the
TV/DVD.
Method 2
Using remote control buttons 0
for VHF/UHF/CATV.
To select a 1 or 2-digit channel number (e. g., Channel 5):
Press 5
To select a 3-digit channel number (e. g., Channel 115):
Press 1 1 5
NOTE
• When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
• If you push "0" by itself, nothing will happen.
• Complete the above steps within a few seconds.

Changing volume/sound

Changing the volume
You can change the volume on the TV/DVD or on the
remote control unit.
Using VOL +/ –
• To increase the volume, press
• To decrease the volume, press
VOLUME
NOTE
• VOL+/ – on the TV/DVD operates the same as VOL+/ –
on the remote control unit.
9 to select channels
–
VOL +
.
VOL –
.
25
13