Connecting A Pc (Personal Computer); Viewing An Image From A Pc; Displaying An Image From A Pc - Sharp Aquos LC 20DV20U Operation Manual

Connecting a PC (Personal computer)

Viewing an image from a PC

Use the INPUT5 (PC) terminals to connect a PC.
NOTE
• The PC input terminals are DDC1/2B-compatible.
• Refer to page 28 for a list of PC signals compatible with the System.
• Make sure to select the same signal values for the output signal of a PC and the input signal of the TV/DVD
set before connecting with the PC. (See page 28.)
• Depending on the PC being used, images may not be shown without converting the output signals into
external output. Please refer to your PC's manuals regarding converting to external output.
Connecting the RGB cable
PC
To Audio output
terminals
Signal names for 15-pin mini D-sub connecter
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11

Displaying an image from a PC

• Connect the RGB cable making sure
that it fits correctly into the terminal.
Then, firmly secure the connectors
by tightening the screws on both
sides of the plug.
To ANALOG RGB To ANALOG
output terminal RGB terminal
RGB cable
(commercially available)
Audio cable
(commercially available)
Pin No. Signal name
1 R
2 G
3 B
4 Not connected
5 CSYNC
NOTE
• Pin No. 5 is not used for inputting the signal.
• Pin No. 9 is not connected with the supplied RGB cable.
To view an image from a PC, perform the
following procedure.
1 Select the INPUT5 (PC) mode using INPUT
on the remote control or the TV/DVD. (See
page 19.)
2 Select the PC input signal. (See page 28.)
3 Adjust the "PICTURE." items if the PC
image does not come in clearly. (See page 28.)
To AUDIO
input terminals
Pin No. Signal name
6 GND (Ground)
7 GND (Ground)
8 GND (Ground)
+ 5V
9
0 GND (Ground)
Pin No. Signal name
11 Not connected
12 SDA
13 HD
14 VD
15 SCL
SOURCE SELECTION
0. TV
1. INPUT1
2. INPUT2
3. INPUT3
4. INPUT4
5. INPUT5
[0-5]:SELECT
27