Installing The Verticutter Blades; Servicing The Roller - Toro Reelmaster 3100-D Series Operator's Manual

Installing the Verticutter
Blades
1. Assemble a reel blade
2. Assemble a large spacer.
3. Do not invert the reel blades when reassembling on
reel shaft.
Note: If the blades are inverted, the blades that are
in use, (rounded) will be mixed with the sharp ends
of the blades which were not in use. This will cause
unsatisfactory performance in the verticutter reel unit.
Attention should always be taken when disassembling
the verticutter blades from reel.
4. Install the next blade clockwise so that the index
reference hole (Figure
blade hole by one flat of the shaft.
1. Index reference hole
5. Continue to install spacers and blades in this manner
until the full complement of blades have been installed.
Note: When properly assembled, the blades will be
staggered in such a manner as to appear like a helix.
6. Install the small spacer to the shaft.
7. Apply Blue Loctite 242 to the nut. Install the nut onto
the shaft, (machined side of nut toward spacer) and
tighten it to 108.5 to 135 N-m (80 to 100 ft-lb).

Servicing the Roller

A Roller Rebuild Kit, Part No. 114–5430 and a Roller Rebuild
Tool Kit, Part No. 115–0803
servicing the roller. The Roller Rebuild Kit includes all the
bearings, bearing nuts, inner seals and outer seals to rebuild a
roller. The Roller Rebuild Tool Kit includes all the tools and
the installation instructions required to rebuild a roller with
the roller rebuild kit. Refer to your parts catalog or contact
your distributor for assistance.
(Figure 14).
14) is not aligned with the first
Figure 14
(Figure 15) are available for
g010890
11