Safety; Safety And Instructional Decals - Toro Reelmaster 3100-D Series Operator's Manual

Safety

This machine has been designed in accordance with EN ISO
5395:2013.
Improper use or maintenance of this equipment can
result in injury or death. To reduce the potential for
injury or death, comply with the following safety
instructions.
•
Read, understand, and follow all instructions in the
traction unit Operator's Manual before operating the
verticutters.
•
Read, understand, and follow all instructions in this
Operator's Manual before operating the verticutters.
•
Never allow children to operate the traction unit or the
verticutters. Do not allow adults to operate the traction
unit or the verticutters without proper instruction. Only
trained operators who have read this Operator's Manual
should operate the verticutters.
•
Never operate the verticutters when tired, ill, or under the
influence of drugs or alcohol.
•
Keep all shields and safety devices in place. If a shield, a
safety device, or a decal is illegible or damaged, repair or
replace it before resuming operation. Also, tighten any
loose nuts, bolts, and screws to ensure that the verticutters
are in safe operating condition.
•
Wear appropriate clothing, including eye protection;
slip-resistant, substantial foot protection; and hearing
protection. Tie back long hair and do not wear jewelry.

Safety and Instructional Decals

Safety decals and instructions are easily visible to the operator and are located near any area of potential
danger. Replace any decal that is damaged or missing.
1. Warning—read the
instructions before
servicing or performing
maintenance.
93-6688
2. Cutting hazard of hand or
foot—shut off the engine
and wait for moving parts
to stop.
•
Remove all debris or other objects that might be picked
up and thrown by the reel blades of the cutting unit. Keep
all bystanders away from the working area.
•
If the verticutter blades strike a solid object or the unit
vibrates abnormally, stop and shut off the engine. Check
the verticutter for damaged parts. Repair any damage
before starting and operating the verticutter.
•
Park the machine on a level surface, lower the cutting
units to the ground, shut off the engine, engage the
parking brake, and remove the key whenever you leave
the machine unattended.
•
Be sure that the verticutters are in safe operating
condition by keeping nuts, bolts, and screws tight.
•
Remove the key from the switch to prevent accidental
starting of the engine when servicing, adjusting, or storing
the machine.
•
Perform only those maintenance instructions described in
this manual. If major repairs are ever needed or assistance
is desired, contact an Authorized Toro Distributor.
•
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement parts
and accessories made by other manufacturers could be
dangerous, and such use could void the product warranty.
decal93-6688
3