Servicing Work; Scheduled Servicing; Customer Maintenance; Cleaning The Offset Roller - Canon Inner Finisher-A1 Service Manual

2
Technology > Servicing Work > Version Upgrade

Servicing Work

Scheduled Servicing

When the endurance time of a part expires soon, replace and/or clean it as required.
Item Part name Expected
service life
Periodically none
replaced
parts
Consumale Stapler 500,000 sheets 1
parts Offset Roller 1,000,000
sheets
Shutter unit 1,000,000
sheets
Paper 1,000,000
retainer(Front) sheets
Paper 1,000,000
retainer(Rear) sheets
Periodically none
serviced
parts
2 Technology > Servicing Work > Version Upgrade
Qty Operation remarks Reference
Replacement p. 4-8
2 Replacement p. 4-9
1 Replacement Static eliminator p. 4-10
at the exit part
1 Replacement Static eliminator p. 4-11
at the entrance
1 Replacement Static eliminator p. 4-11
at the entrance

Customer maintenance

■

Cleaning the offset roller

•
Details
Offset roller should e cleaned once a month to maintain the accuracy of the stacking
alignment as foreign articles like dust are likely to stick to the roller.
•
Instruction
1) With holding up the roller a little, rub off paper dusts, etc. by a moist cloth.
T-2-1 T-2-1
MEMO:
If the optional tray is installed, it is easier to clean the rollers just after delivering a paper
onto the optional tray since the optional tray gets descended lower than the rollers.

Version Upgrade

Upgrade the firmware of the finisher controller according to the upgrade procedure
descried in the service manual of the host machine.
This finisher does not support upgrading via downloader PCB (FY9-2034).
2-5
F-2-8 F-2-8
2-5