Removing The Motors; Removing The Shift Roller Release Motor - Canon Inner Finisher-A1 Service Manual

4
Parts Replacement and Cleaning Procedure > Removing the Motors > Removing the Shift Roller Release Motor

Removing the Motors

Removing the Shift Roller Release Motor

1) Remove three screws and then the inner cover.
x3
3) Remove six screws and then the upper guide.
x6
4 Parts Replacement and Cleaning Procedure > Removing the Motors > Removing the Shift Roller Release Motor
2) Remove the additional tray PCB along with the mount (only when the additional tray is
installed).
x1
F-4-45 F-4-45
4) Disconnect the relay connector of the shift roller disengage motor cale.
5) Remove the cable from one wire saddle and two harness guides.
x1
F-4-47 F-4-47
x3
4-18
F-4-46 F-4-46
F-4-48 F-4-48
4-18