Table of Contents
Advertisement
Setup
Use the following procedure to set up the system using this terminal.
Setting procedure
1. Connect the cables to each camera.
2. Turn the camera terminal SW which is set on terminal to ON. Set other cameras to OFF.
(figure 1
)
3. Set the address for each camera using "CAMERA SETUP".
Do not use the same address.
4. Set the communication speed using "CAMERA SETUP". Set the same value for each
camera.
Use the following procedure to control the DAY&NIGHT function externally.
Setting procedure
1. Set "DAY&NIGHT" to "EXT." in "FUNCTION SET.".
2. Change the DAY&NIGHT function mode by inputting the control signal.
H input or open : Operates in AUTO mode
L input or short: Operates in black/white mode
(This terminal is pulled up inside the camera. There is no ability to drive an external device.)
<Ratings and Electrical Characteristics>
Rating input voltage V
High level input voltage V
Low level input voltage V
Use within the above values.
:
-0.3 ~ 3.3 V
IN
: Min.3.0 V
IH
: Max.0.3 V
IL
En-24
Advertisement
Table of Contents
