Multiple Commands; Heat Pump Model Setup - Toshiba Combi control User Manual

Multiple commands

If you want to set up several parameters with one SMS, separate commands with one of the
following:
space
comma ","
semicolon ";"
For example, the SMS „91+49550111111 92+49550222222 9522 9720"
sets the User1 and User2 numbers, specifies the heat pump model as "Toshiba Daiseikai 5",
and determines that NO POWER message will not be sent in case of a power failure.
When a command in the multi-setup is incorrect, the Owner will receive an error message.
All the correct commands that precede the error command in the multi-setup command
will be activated.
Multi-setup sender will always receive SETUP report SMS from Combi Control to confirm
that all commands arrived to the controller. There can be spaces before and after a
command but not inside a command as this will interfere with the code.
32

Heat pump model setup

The pump can be chosen on 3 levels of precision:
1. The precise name of the pump: the manufacturer and the model.
This is recommended for the most efficient operation.
2. Pump manufacturer.
If you only choose the pump manufacturer, functions T8 will not be checked and the
command will be sent even if the pump does not have
T8 mode. If the exact pump model is not listed on our webpage or in this manual,
Combi Control may or may not work with the heat pump, for which the Combi Control
manufacturer will not be held responsible.
3. All pump models.
If you choose All pump models (SMS: "950"), then all supported brands IR commands will
be sent to the pump, and Combi Control can be used without choosing the pump more
precisely.
33