Setting Up Screen Call - Sanyo SCP-7200 Operating Manual

Setting Up Screen Call

This feature enables you to answer incoming calls by using pre-recorded
announcements, either one that came with the phone or one that you record. You can
also record the caller's voice into the Voice Memo list (See "Recording Memos" on page
66). You can decide whether you answer the call immediately or not during the
caller's recording.
Activating Screen Call
To start Screen Call when you have incoming calls:
1. Press Menu/OK to display the options.
2. Highlight Screen Call, and press Menu/OK.
To set Auto Screen Call:
1. From the Standby mode, press Menu/OK to display the main menu.
2. Highlight VoiceService, and press Menu/OK.
3. Highlight Screen Call, and press Menu/OK.
4. Highlight Auto, and press Menu/OK.
5. Highlight On, and press Menu/OK.
If you want to change the answer time, enter your desired number (from 1 to 16
l
seconds) by using numeric keys or up/down of the Navigation key.
6. Press Menu/OK or OK (left softkey). Then the icon is displayed on the Standby
display.
Tip: If new caller's message is waiting,
while activating "Screen Call" are shown with " " or " ! " icon in the list. ("
played, !: not played yet)
Tip: While the caller 's recording:
Pressing END/ stops recording and disconnects the call.
Pressing TALK answers call.
Selecting Announcement for Screen Call
1. From the Standby mode, press Menu/OK to display the main menu.
2. Highlight VoiceService, and press Menu/OK.
3. Highlight Screen Call, and press Menu/OK.
4. Highlight Announcement, and press Menu/OK.
5. Depending on your preference ,select Pre-Recorded or Custom .
6. Press Menu/OK.
Recording Name for Pre-Recorded Announcement
1. From the Standby mode, press Menu/OK to display the main menu.
2. Highlight VoiceService, and press Menu/OK.
appears on the display. The memos recorded
68
" : once