Remote Control; Handling And Operation - Silvercrest KH 2377 Operating Instructions Manual

Remote control

GB
IE
Inserting the battery
Using the remote control

Handling and operation

16
NOTICE
► The supplied battery (Type CR2025) is already installed in the remote
control when delivered. Before use remove the isolation strip from the
battery compartment.
For replacement with a new battery procede as follows:
Pull the battery compartment out of the remote
control by pressing the lateral locking device and
at the same time pull the battery compartment out.
Remove the depleted battery and insert a new
battery of the type CR2025 (Button cell) into the
battery compartment. Be sure to insert the battery
with the correct polarity.
Slide the battery compartment back into the remote
control until it locks into place.
Point the remote control to the Infrared sensor
device.
NOTICE
► You can use the remote control up to a distance of 8 m from the device.
In this chapter you receive important information for the handling and operation
of the device.
NOTICE
► Most of the functions can be operated by the buttons on the device as well
as by the buttons on the remote control. In these instructions operation via
the buttons on the device is described. Any reference to the push buttons
on the remote control will be specifi cally highlighted.
► If no setting is made and/or no button pushed within approx. 5 seconds the
device returns to its previous operating mode. Changed settings are saved.
Handling and operation
on the front panel of the
4
KH 2377