Related Manuals for Silvercrest SDBK 2200 A16
Summary of Contents for Silvercrest SDBK 2200 A16
- Page 1 Steam Iron SDBK 2200 A1 Steam Iron Operating instructions KOMPERNASS GMBH BURGSTRASSE 21 · D-44867 BOCHUM www.kompernass.com ID-Nr.: SDBK2200A1-07/10-V2...
- Page 2 SDBK 2200 A1...
-
Page 3: Table Of Contents
Tips for utilisation Operation Filling with mains water...4 Plugging in and ironing Steam ironing Ironing with steam blast Temporarily setting the steam iron aside Taking the steam iron out of service Drip-Stop Function Cleaning Self-cleaning function ...6 Housing ...7 Metal parts...7 Troubleshooting... -
Page 4: Intended Use
All other use is deemed improper use. Safety instructions Risk of burns! • Grasp the steam iron only by the handle when it is hot. • This appliance is not intended for use by individuals (including children) with restricted physical, physio-... -
Page 5: Items Supplied
The proximity of moisture presents a danger, even when the appliance is switched off. • You may not open the housing of the steam iron. Permit only authorised technicians to repair a defective appliance should repairs be necessary. -
Page 6: Tips For Utilisation
• Place the temperature regulator 7 into the position "MAX". • Heat the steam iron up for several minutes at this highest setting. • Remove the steam iron from the station q (see chapter “Tips for utilisation”). • Press the button for the steam blast 5 a few times such that steam exits from the soleplate e. -
Page 7: Plugging In And Ironing
Ironing with steam blast The steam blast is especially suitable for smoothing difficult to reach parts of a garment. • Slightly raise the steam iron. • For a steam blast, press the steam blast button - 5 - Symbol... -
Page 8: Temporarily Setting The Steam Iron Aside
Never leave the steam iron unattended when it is hot or switched on. • Place the temperature regulator 7 into the position "MIN". • Place the steam iron only on the cable base 8 or insert it onto the station q. Taking the steam iron out of service •... -
Page 9: Housing
Fill the water tank with mains water (See "Filling with mains water"). The steam iron does not get hot: The steam iron is not plugged in or is not switched on. Insert the plug into a wall power socket and adjust the temperature regulator 7 to the desired ironing temperature. -
Page 10: Importer
The warranty period will not be extended by repairs made under warranty. This applies also to replaced and repaired parts. Any damage and defects extant on purchase must be reported immediately after un- packing the appliance, at the latest, two days after the purchase date.