Dell ChengMing 3980 Setup And Specifications page 17

Table 18. System Configuration
Option
Integrated NIC
Serial Port
SATA Operation
Drives
Smart Reporting
USB Configuration
Front USB Configuration
Rear USB Configuration
Description
Allows you to control the on-board LAN controller. The options are:
• Enable UEFI Network stack
• Disabled
• Enabled
• Enabled w/PXE (default)
NOTE: Depending on the computer and its installed devices, the items listed in this section
may or may not appear.
Identifies and defines the serial port settings. You can set the serial port to:
• Disabled
• COM1 (default)
• COM2
• COM3
• COM4
Allows you to configure the operating mode of the integrated hard drive controller.
• Disabled = The SATA controllers are hidden
• AHCI
• RAID On (default)
Allows you to enable or disable the various drives on-board:
• SATA-0
• SATA-1
• SATA-2
• SATA-3
• M.2 PCIe SSD-0
Default Setting: All drives are enabled.
This field controls whether hard drive errors for integrated drives are reported during system startup.
This option is disabled by default.
Allows you to enable or disable the integrated USB controller for:
• Enable Boot Support
• Enable Front USB Ports
• Enable Rear USB Ports
All the options are enabled by default.
Allows you to enable or disable the Front USB configuration. The options are:
• Front Port 1 (Left)*
• Front Port 2( Right)*
• Front Port 3 (Left)*
• Front Port 4 (Right)*
All the options are enabled by default.
* denotes a USB 3.0-capable port
Allows you to enable or disable the rear USB configuration. The options are:
System setup 17