Panasonic M41A1G4L Operating Instructions Manual page 24

Handling instructions
Safety Precautions
Caution
Don't move the motor by holding cables or motor shaft.
Don't drop or cause topple over of something during
transportation or installation.
Don't step on the product. Don't place heavy object on
the product.
Don't use the equipment under direct sunshine.
Don't use the equipment in highly intensive electric field.
Don't use the equipment in an environment where
electro-static voltage potentials may be produced.
Don't block the motor air opening by an object.
Don't apply excessive shock to the product.
Don't apply excessive shock to the motor shaft.
Don't turn off and on power so frequently.
Don't put the machine into unstable operation.
Don't energize the C&B motor clutch and brake at the
same time.
Don't use smaller variable transformer or transformer.
Don't pull cables with an excessive force.
Don't lock the motor shaft while the motor is running.
Once power failure occurs, don't come close to the
machine that will unexpectedly start upon recovery of
the power.
Provide secure mechanism so that the restarting of the
machine will not cause personal injury.
Don't operate the product outside its ratings stated on
the nameplate and instruction manual.
Never attempt to perform modification, disassembly or
repair.
Panasonic Corporation Electromechanical Control Business Division
industrial.panasonic.com/ac/e/
Failure to heed these precautions
cause bodily injury.
Failure to heed this instruction will
result in personal injury or
malfunction.
Failure to heed this instruction will
result in electric shock, personal
injury, malfunction or damage.
Failure to heed these instructions
will cause personal injury or fire.
Induced malfunction will cause
personal injury.
Failure to heed this instruction will
result in electric shock or fire.
Excessive shock will cause failure.
Failure to heed this instruction will
result in personal injury, fire,
malfunction or damage.
Failure to heed these precautions
cause bodily injury.
Failure to heed this instruction will
result in fire, electric shock, or
malfunction.
Failure to heed this instruction will
result in electric shock, personal
injury or fire.
Locked motor will cause fire,
electric shock, or malfunction.
Failure to heed these precautions
cause bodily injury.
Failure to heed this instruction will
result in personal injury, electric
shock, fire, malfunction or damage.
Failure to heed this instruction will
result in fire, electric shock or
personal injury.
– A-44 –
© Panasonic Corporation 2018 AQCTB02E 201806-E
Perform installation by taking into consideration the
mass of the body and rated output of the product.
Exactly follow the installing method and direction
specified.
Don't place any obstacle object around the motor and
peripheral, which blocks air passage.
Adjust the motor and speed controller ambient
environmental condition to match their operating
temperature and humidity.
Connect a ground-fault interrupter, circuit breaker and
relay to the brake control relay in series so that they are
turned off upon emergency stop.
Provide protection device against slipage of brake or
gear head, or grease leakage from gear head.
Always install a safety system that will back up the
braking system failing to operate due to power
interruption or voltage drop.
Use the speed controller in combination with the
specified motor.
Level of input voltage to a peripheral block should
correspond to the motor rated voltage.
Test-run the securely fixed motor without load to verify
normal operation, and then connect it to the mechanical
system.
Maintenance must be performed by an experienced
personnel.
Always keep power disconnected when the power is not
necessary for a long time.
Scraps must be treated as industrial waste.
Panasonic Corporation Electromechanical Control Business Division
industrial.panasonic.com/ac/e/
Caution
Incorrect installation or mounting
will cause personal injury or
malfunction.
Temperature rise will cause burn
injury or fire.
Incorrect installation or mounting
will cause personal injury or
malfunction.
Missing of one of these devices will
cause malfunction.
Lack of protection will cause
personal injury, damage or
pollution.
Lack of protection will cause
personal injury, damage or
malfunction.
Incorrect combination will cause
fire.
Operation from a voltage outside
the rated voltage will cause electric
shock, personal injury or fire.
Operation with a wrong model or
wrong wiring connection will result
in personal injury.
Wrong wiring will cause personal
injury or electric shock.
Improper operation will cause
personal injury.
– A-45 –
© Panasonic Corporation 2018 AQCTB02E 201806-E