Table of Contents
Advertisement
Simple Network Management Protocol (SNMP)
(21) snmp trap select command [enable/disable]
Sets/Unsets MSB-2000/MSBA-20IP commands as
a trap.
This command is available when the trap switch is
set to enable_select.
This command is resumed.
(22) snmp trap select status [enable/disable]
Sets/Unsets MSB-2000/MSBA-20IP status as a
trap.
This command is available when the switch is set
to enable_select.
This command is resumed.
(23) snmp trap select summary [enable/disable]
Sets whether or not to output a summary trap.
This command is resumed.
If the argument is omitted, the error message
"invalid parameter" is returned.
Note
A "summary trap" refers to the following seven
logs.
• 30030035 Status SDI/SDTI input present/absent
• 30030036 Status ASI input present/absent
• 30030076 Status --- Tx is up ---
• 30030077 Status --- Rx is up ---
• 30030073 Status RTP link status up/down
• 12053010 Picture Freeze (Rx)
• 10053010 Picture Freeze (Rx) (CLEAR)
The following specific example settings output the
above seven traps only within the status log, minor
log, and clear minor log:
snmp trap select summary enable
snmp trap select status disable
snmp trap select minor disable
snmp trap select clear_minor disable
By this means, the trap traffic can be reduced.
92
Advertisement
Table of Contents
