Multiple User Operation; Usage Limits - Panasonic UB-T880 Manual

Drawing function
The Selection Dial can be used to change the color being drawn, and can be used to erase the displayed
drawing.
Mouse function
Setting the Selector Dial to Mouse lets you perform the same operations as using your finger.
While holding down the menu button, touch the pen to the screen board
The Drawing Menu appears from where a number of different functions can be selected.
(The Drawing Menu is not displayed while the Selector Dial is set to Mouse.)
Press the up button
Performs the same function as pressing the Page Up key on the computer.
Press the down button
Performs the same function as pressing the Page Down key on the computer.

Multiple User Operation

With the UB-T880 series, multiple users can draw the screen board at the same time.
Limits to simultaneous operation
• A maximum of 3 touch spot points are allowed at any one time.
The UB-T880 series can detect up to 3 spots at the same time. Touching more than 3 spots at the
same time can result in erroneous operation.
• During operation, avoid touching spots erroneously while working.
The UB-T880 series detects where the board is touched. Erroneous operation can occur in the
following situations:
– Performing operations while touching the screen board.
– Performing operations while the hand that was holding the pen is still touching the screen board.
• Do not touch a spot that is close (within 10 cm [4 in.]) to where you are operating.
Touching multiple points within a close area (10 cm [4 in.]) may be recognizes as a single touched
point, or if in freehand line mode cause connections or intersections of other drawn lines.

Usage Limits

Do not do any of the following, as they might result in erroneous operation:
• Do not operate 2 or more elite Panaboards in close proximity to each other.
Using multiple electronic pens at the same time can cause erroneous operation.
• Do not connect 2 or more elite Panaboards to a single computer.
They will not operate correctly.
Note
• The mouse position is reset and may move on the left-upper corner when the power is turned off or the
USB cable is disconnected. In this case, a function specified by Active Screen Corners may be
performed.
• When turn the power switch on after turning off or reconnect the USB cable, wait 5 seconds or more.
• When screen saver is executed during use, change time for screen saver starting.
― 7 ―