Introduction; Gt Models And Versions Connectable To Fp7; Restrictions - Panasonic GT series Connection Manual

1. Introduction

This manual describes how to use programmable displays GT02/GT02L/GT05/GT12/GT32/GT32-E
connecting to FP7. Also refer to GT series Reference Manual (ACGM0357V6EN) and GT series User's
Manual (ARCT1F511E).
As for requesting for manuals, please contact your dealer or download the PDF data from our web site.
http://industrial.panasonic.com/ac/e/dl_center/manual/ (User registration is required. Free of charge)

1.1 GT Models and Versions Connectable to FP7

For using GT series connecting to FP7, the versions of GT series and tool software GTWIN applicable to
FP7 are required. For information on the applicable versions, refer to the table below.
If you use an old version of GTWIN, download the upgrade version from our web site to upgrade the old
version.
The firmware of GT series can be upgraded from tool software GTWIN. Firmware files can be also
downloaded from our web site.
http://industrial.panasonic.com/ac/e/dl_center/software/ (User registration is required. Free of charge)
Applicable versions to FP7
GT model
GT02
GT02L
GT05
GT12
GT32
GT32-E
Other GT series
GTWIN

1.2 Restrictions

There are the following restrictions on using GT series connecting to FP7.
The FP monitor function cannot be used.
Projects of FP7 (such as programs) cannot be uploaded or downloaded from the SD memory card slot of
GT. Use the SD memory card slot of FP7.
GT and FP7 cannot be connected via Ethernet.
A baud rate of 230400 bps cannot be used for connection. Set the baud rate and communication format
within the ranges usable for GT series.
The internal clock of FP7 cannot be changed from GT.
2
Applicable version to FP7
Ver.1.50 or later
Ver.1.40 or later
Ver. 2.10 or later
Ver. 1.80 or later
Ver. 2.20 or later
Ver. 1.20 or later
Cannot be used.
Ver. 2.D0 or later