Checking Via The Utility - NEC N8103-102 User Manual

2.
Confirm that the screw holes on the standoffs are lined up with the screw holes on the rear side of
the RAID board.
Carefully insert 3 screws from the back of the board through the holes on the standoffs.
* To remove the additional battery from the RAID board, see the following procedure.
3.
Remove the 3 screws from the rear side of the RAID board, and store them safely.
4.
Pull out the additional battery from the battery connector.

2. Checking via the Utility

Refer to the MegaRAID Storage Manager
TM
User Guide.
23