Handling Of The Laser And The Line Camera - Panasonic KXF-E64C Maintenance Manual

Handling of the laser and the line camera

Since the level of the laser and the line camera is class 1 (IEC60825-1), these are basically safe under
a normal usage pattern. In maintenance or operation, however, avoid looking directly at them.
1.Line camera
Each camera is installed at the front and the rear of the machine. When the twin tray (DT45T) is
connected with the rear of the machine, however, the camera is not installed on the tray side.
The maximum output of the LED components used in this machine is 15 mW. The line camera has
such a structure as will not expose workers directly to the LED radiation if they open its cover. For
safety's sake, however, never open the cover of the line camera.
E64C-AC00
2.Laser
The laser unit can be installed at the front and the rear of the machine. This unit is optional.
The maximum output of the laser components used in the laser unit is 3 mW. The sensor head has
such a structure as will not expose workers directly to the laser radiation if they open its cover. For
safety's sake, however, never open the cover of the sensor head.
E64C-AC00
Page 20
E64C-007E
Item
Manufacturer Panasonic Factory Solutions Co., Ltd.
Model number
Wavelength
Output
Class
Emission duration
Installation location
E64C-008E
Item
Manufacturer
Model number
Wavelength
Output
Class
Detection method
Installation location
LED specifications
KXFK001LA00
850 nm
5.32 mJ
Class 1
6.2 sec (Maximum)
See the left figure.
Laser specifications
Anritsu Corporation
KXF05GDAA00
850 nm
0.061 mW
Class 1
Scanning per 60 µ second
See the left figure.
E64C-E-XXA00-A04-00