HP 5973 Hardware Installation Manual page 2

© Copyright 1998
Hewlett-Packard Company
All Rights Reserved.
Reproduction, adaptation, or
translation without prior
written permission is
prohibited, except as allowed
under the copyright laws.
® ®
Microsoft and Windows NT
are U.S. registered trademarks
of Microsoft Corporation.
Document History
Publication number
G1099-90006
First edition, 2/98
Printed in USA
Warranty
The information contained in
this document is subject to
change without notice.
Hewlett-Packard makes no
warranty of any kind with
regard to this material,
including, but not limited to,
the implied warranties of
merchantability and fitness for
a particular purpose.
Hewlett-Packard shall not be
liable for errors contained
herein or for incidental or
consequential damages in
connection with the
furnishing, performance or use
of this material.
Hewlett-Packard assumes no
responsibility for the use or
reliability of its software on
equipment that is not
furnished by Hewlett-Packard.
Noise Declaration
Deutsch
LpA << 70 dB am Arbeitsplatz
normaler Betrieb nach EN
27779:1991
English
LpA << 70 dB operator
position normal operation per
ISO 7779:1988
Instrument
Identification
Each HP 5973 MSD is
identified by a unique 10-
character serial number. This
serial number is located on a
label on the lower left side
near the front of the
instrument. On CI upgrades, a
serial number is posted on the
flow module.
When corresponding with
Hewlett-Packard about your
instrument, be sure to include
the model number and both
full 10-character serial
numbers.
Manual Conventions
Cautions
Cautions call attention to
procedures which, if not
correctly performed or
adhered to, could result in
damage to the instrument.
Warnings
Warnings call attention to
procedures which, if not
correctly performed or
adhered to, could result in
personal injury.
Part Numbers
In this manual, Hewlett-
Packard part numbers are
generally listed in parentheses
after the name of the part or in
tables in the Parts chapter.
Most Hewlett-Packard part
numbers are either four-digit-
by-four-digit (1234-1234)
numbers or five-digit-by-five-
digit (12345-12345) numbers.
A few tools and supplies listed
have no part numbers and are
not available from Hewlett-
Packard. Most of these can be
obtained from laboratory
supply companies.
Safety Information
Safety Symbols
The following symbols may be
posted on HP instruments:
;
Refer to operating
instructions
=
Indicates hazardous
voltage
+
Indicates hot surface
3
Indicates earth
(ground) terminal
Safety Information
Safety class
The HP 5973 Mass Selective
Detector (MSD) is a Safety
Class I instrument and has
been designed and tested in
accordance with IEC
Publication 1010-1 Safety
Requirements for Electrical
Equipment for Measurement,
Control, and Laboratory Use.
WARNING
Connecting an MSD to a power
source which is not equipped
with a protective earth contact
creates a shock hazard for the
operator and can damage the
instrument. Likewise,
interrupting the protective
conductor inside or outside
the MSD or disconnecting the
protective earth terminal
creates a shock hazard for the
operator and can damage the
instrument.
WARNING
Make sure that only fuses with
the required current rating
and of the specified type are
used for replacement. The use
of incorrect or makeshift fuses
or the short-circuiting of fuse
holders creates a shock hazard
for the operator and can
damage the instrument.
WARNING
Any adjustment, maintenance
or repair of the opened
instrument while it is
connected to a power source
should be avoided if possible
and, if required, should be
carried out only by trained
persons who are aware of the
hazards involved.
Safety Information continued
on the inside of the back
cover.