Integrating The Gc, Msd, And Chemstation - HP 5973 Hardware Installation Manual

Integrating the GC, MSD, and ChemStation

Materials needed:
MSD ChemStation software installation manual (G1701-90031)
1 6WDUW XS WKH &DUERQ &RS\ VRIWZDUH DQG FRQILJXUH WKH PRGHP LI \RXU
&KHP6WDWLRQ LQFOXGHV D PRGHP
2 ,Q WKH 3URGXFWLYLW\ 7RROV JURXS FOLFN WKH 06 &RQILJ LFRQ DQG FRQILJXUH
WKH 06' DQG *& IRU WKH 06' &KHP6WDWLRQ VRIWZDUH
Be sure to select
3 &OLFN RQ WKH LQVWUXPHQW LFRQ WR VWDUW XS WKH 06' &KHP6WDWLRQ VRIWZDUH
4 0RQLWRU WKH SXPS GRZQ 7KH 06' VKRXOG DOUHDG\ EH SXPSLQJ GRZQ EXW
QRZ \RX FDQ PRQLWRU WKH VWDWXV
— Select
— When the pumpdown is complete, follow the instructions to set the GC/MSD
5 (QWHU SDUDPHWHUV LQ
IDFWRU\
— In the Diagnostics/Vacuum Control view, select
— Select
— Click
6 3HUIRUP D SURILOH VFDQ
— Click
— Click
— Click
— Do not run Autotune or the Air and Water Check at this time. The MSD must
7 6DYH WKH WXQH SDUDPHWHUV
Select
Chemical Ionization
Diagnostics / Vacuum Control
Vacuum menu.
interface temperature to 280°C.
ATUNE.U
Diagnostics menu. Edit parameters as necessary.
from the MoreParams menu. Verify the MSD temperatures:
Temperatures
MS Source: 230°C
MS Quad: 150°C
to close the MS Zones dialog box.
OK
. Verify that there are peaks visible for all three masses.
Prof
. Click .
Stop MSOff
to close the Edit Parameters window.
OK
stabilize for at least 60 minutes.
Save Tune Values from the File menu.
,QWHJUDWLQJ WKH *& 06' DQG &KHP6WDWLRQ
for the CI MSD.
from the View menu. Select
WR PDWFK WKRVH LQ WKH WXQH UHSRUW IURP WKH
Edit MS Params
 Installation
from the
Pumpdown
from the
29