Advertisement
PIN DESCRIPTION
RJ-45 Connector Pin Description
Pin# 1: VCC, DC power (10V ~ 16VDC)
Pin# 2: GND
Pin# 3: Audio Signal
Pin# 4: Audio Signal GND
Pin# 5: GND
Pin# 6: 2.8V out when the unit is on. Short this pin
to GND to remotely turn on TX.
Normal "H" 5.0V
0V
Pin# 7 : 0V when TX is ON, 5V when TX is OFF.
Use this pin for recording trigger (Recording Trigger)
Normal "H" 5.0V
0V
Pin# 8 : FULL UP 5V 470 OHM
1
8
8
1
Recording starts
TX unit is on
FUNCTIONS
- 95 Channel Possible in the 2400~2483MHz Bandwidth
- Transmission Range up to 1500 feet in open field
- Audible and LED indicator out of range warning.
- Better voice quality.
- 40 bits security code combination.
- Charger Status Indicator
- Mute function On/Off Key (Transmitter)
- Auto link (When the system On/Off is On mode)
- Recorder On/Off Switch
- Transmitter Power On/Off switch
- Low Battery Indicator (Transmitter)
- Link LED indicator (Receiver & Transmitter)
- Beep Mode and Vibration Mode Selectable for user's convenience
TROUBLESHOOTING
Problems
- Check the battery status
No reception
- Check the connection and cables
- Check the communication range
- Change the location of RX Set
Poor reception,
- Check the communication range
static, noise
- Check to see if unit is placed near TV,
speakers, or other electronic devices
- Check the battery status
Unit does not
- Check the power switch on the bottom of
respond
the unit
- Check the connection and cables
Check Points
Advertisement
