Assembling The Stand - Pioneer PDK-TS25 Operating Instructions Manual

Assembling the Stand

Note
Always assemble it on a flat table etc.
Insert the screws in the holes vertically and do not tighten
them with more force than necessary.
Assembly Procedure
1
Select the support columns to attach.
Select the support columns according to the plasma
display that you have purchased (Only one type of the
two types of available support columns should be used).
When the plasma display you have purchased is
PDP-507XD/507XA(under speaker models).
[Support column used: support column L (long
columns)]
Support column used:
support column L
(long columns)
When the plasma display you have purchased is
PDP-507XD/507XA(except under speaker models)/
PDP-427XD/427XA.
[Support column used: support column S (short
columns)]
14
En
Support column used:
support column S
(short columns)
2
Secure the support column to the stand
with the Installation screws 1 (4 locations
on the left and right).
Using the enclosed hexagonal wrench, first loosely
attach the top attachment screw, then loosely attach
the bottom attachment screw.
The larger holes
are on the front.
Installation screws
(M8 x 16 mm: silver)
3
Fully tighten the Installation screws
(4 locations on the left and right).
Fully tighten the attachment screws.
Note
Be sure to carefully store the unused support columns, the
hexagonal wrench, the C wrench, and the Operating
Instructions together.
The weight of a 50 inch Plasma Display(without
speaker) is about 34.1 kg (75.2 lbs), that of a 42 inch
model is about 29.0 kg (63.9 lbs), they have no
depth, and are unstable. Therefore, at least two
Caution
people must assemble and install them.
Note
Be sure to install it on a flat stable location.
Insert the screws in the holes vertically and do not tighten
them with more force than necessary.
Make sure that you install the support columns reliably
with reference to the procedure in "Assembling the
Stand".
1