Forward/Backward Angle Of Inclination Adjustment Mechanism - Pioneer PDK-TS25 Operating Instructions Manual

Forward/Backward Angle of Inclination Adjustment Mechanism

On this stand, you can adjust the angle of inclination of the
Plasma Display within a range of approximately 2° forward
or backward according to your preference.
Note
Be sure to adjust the angle only after you have
attached the Plasma Display.
Be sure to install it on a flat table or other flat
surface.
Be sure to hold the top of the Plasma Display
with your hand while adjusting the angle.
Adjustment Procedure
1
Loosen the forward/backward inclination
anchor bolts using the enclosed C wrench
(2 locations on the left and right).
While being sure to hold the top of the Plasma Display
with your hand, loosen the forward/backward
inclination anchor bolts on the left and right sides by
rotating them upwards using the enclosed C wrench.
*Figure shows the 50 inch display model.
2
Set the angle you prefer.
Set the angle you prefer by slowly moving the Plasma
Display.
Note
While adjusting the angle, be very careful to keep your
hands out of the place indicated by the arrow on the figure.
16
En
Forward/backward
inclination anchor bolt
Loosening
3
Tighten the forward/backward inclination
anchor bolts (2 locations on the left and
right).
Firmly tighten the forward/backward inclination
anchor bolts on the left and right sides by rotating
them downward using the enclosed C wrench.
Be sure to hold the top of the Plasma Display with your
hand until you have fully tightened the bolts.
Forward/backward
inclination anchor bolt
4
Check once more to make sure that the
forward/backward inclination anchor bolts
are fully tightened.
Tightening