Panasonic WJ-ND300 Maintenance Manual page 11

WJ-ND300 SATA conversion guide (single)
(28) Adjust the length of SATA cables and secure them as shown below.
for HDD1
(29) Make the cables flat at an intersection as shown right.
(30) Insert convex portions of bottom plate into the holes in the
main unit chassis, and secure it with ten screws (7x wafer-
head screw, 3x binding screw).
(31) Insert convex portions of three HDD rails into the holes in
the bottom plate, and secure them with two screws each.
Note: Beware of cables
Panasonic
for HDD3
for HDD2
Approx. 30mm
for HDD4
11
ND300_SATAConversionGuideS_A
Maintenance guide
Common to left and right
Approx. 50mm