Dell EqualLogic FS7610 Series Hardware Owner's Manual page 20

Dell EqualLogic FS7610 Hardware Owner's Manual
Installing a Power Supply
1. Slide the new power supply into the appliance until the release latch clicks into place. See
2. Connect the power cord to the power supply, then connect the other end to the power source.
3. Secure the cord with the strain relief strap.
4. Make sure the power supply LED illuminates.
When installing a new power supply, allow several seconds for the system to recognize the power supply
and determine its status. The power-supply status indicator turns green to signify that the power supply is
functioning properly (see
Removing the Bezel
If you need to access fans, or remove the bezel for any other reason, see
1. Use the key to unlock the bezel, if it is locked (callout 1).
14
Figure 10: Removing a Power Supply
Figure 11: Installing a Power Supply
Table 5).
2 Replacing Components
Figure
Figure 12 and follow these steps:
11.