Canon Finisher-R1 Service Manual page 40

Chapter 2
Swing guide home position sensor (PI35)
Swing motor (M36)
■ Second and Subsequent Sheets
The finisher controller PCB starts the swing motor (M36) and lowers the swing guide when the rear end of the 2nd
paper passes the 1st delivery roller. The stack delivery motor is reversed. The stack delivery motor rotates the stack
delivery roller (upper) and return roller and sends the paper to the processing tray. At this point, the stack delivery
2-16
Stack ejection roller
Swing guide
1st delivery roller
Processing tray
F-2-21
Stack ejection lower roller cluch (CL32)
Stack ejection motor (M32)
F-2-22
Return roller
Stapler
Stack ejection roller (upper)
Stack ejection roller (lower)
Swing guide