Making Adjustments; Adjusting The Height/Tilt - Canon Finisher-R1 Service Manual

F-3-30
3) If the height/tilt is correct, end the installation work
by referring to "Work After Making Checks/
Adjustments." If the height/tilt is not correct, see the
instructions in "Adjusting the Height/Tilt."

3.2.3 Making Adjustments

3.2.3.1 Adjusting the Height/
Tilt
If the height or the tilt of the finisher and the host
machine is not as indicated, go through the
following steps to make an appropriate correction:
■ Preparing for Adjustment
<Finisher-R1>
In the case of the Finisher-R1, you will need to
remove its auxiliary ring and rear foot cover. Be
sure to remove the auxiliary ring with the finisher
and its host machine intact, thus preventing the
machine from tumbling over.
1) If you need to adjust the height at the rear, remove
the 4 screws [1], and detach the auxiliary plate [2].
2) Remove the 2 screws [3], and detach the left rear
foot cover [4].
3 1.5mm
3) From the back of the removed front cover, remove
the fixing screw, and detach the pliers [1].
0003-1769
<Saddle Finisher-R2>
[1]
[1]
F-3-31
[1]
F-3-32
Chapter 3
[3]
[4]
[2]
3-13