Making Adjustments; 1Adjusting The Height/Tilt - Canon Finisher-R1 Installation Procedure

Chapter 1

1.4 Making Adjustments

1.4.1 Adjusting the Height/Tilt
If the height or the tilt of the finisher and the host machine is not as indicated, go through the following steps to
make an appropriate correction:
■ Preparing for Adjustment
<Finisher-R1>
In the case of the Finisher-R1, you will need to remove its auxiliary ring and rear foot cover. Be sure to remove
the auxiliary ring with the finisher and its host machine intact, thus preventing the machine from tumbling over.
1) If you need to adjust the height at the rear, remove the 4 screws [1], and detach the auxiliary plate [2].
2) Remove the 2 screws [3], and detach the left rear foot cover [4].
3) From the back of the removed front cover, remove the fixing screw, and detach the pliers [1].
18
[1]
[1]
F-1-31
[3]
[4]
[2]
0003-1769