Hitachi Compute Rack 220H Replacement Manual page 34

•
LAN mezzanine (CN7M1S-Y/ CN7M1S-R): 10GBASE-T SFP+
Figure 1-11: LAN mezzanine (CN7M1S-Y/ CN7M1S-R) status LED
Table 1-12: LAN mezzanine (CN7M1S-Y/ CN7M1S-R) status LED indicate
Location
1
2
1-14
1
2
Name
Link LED
Activity LED
Onboard LAN controllers of the optional LAN mezzanine displayed
•
by the device manager are as follows:
LAN controller 1: PCI bus 6, device 0, function 0
–
LAN controller 2: PCI bus 6, device 0, function 1
–
The number of the network adapter which is the network interface
•
connector recognized by the device manager may not match to the
network interface connector number.
LAN mezzanine (CN7M1T-Y/CN7M1T-R) interfaces support link
•
speed is 10 Gbps and 1 Gbps (10GBASE-T and 1000BASE-T). If the
links speed of the LAN mezzanine (CN7M1T-Y/CN7M1T-R) is 100
Mbps or 10 Mbps (100BASE-TX or 10BASE-T link established, the
Link LED is lights solid amber), you need to reconfigure the network
connected to the LAN mezzanine interface. In this case, the Link
LED is lights solid amber as well as if the link speed is established
with 1000 Mbps (1000BASE-T). Be careful because you cannot
discriminate a linking speed (10 Mbps, 100 Mbps or 1000 Mbps) by
lighting status the Link LED.
LAN mezzanine (CN7M1S-Y/CN7M1S-R) interfaces support link
•
speed is only 10 Gbps (10GBASE-SR). If the links speed of the LAN
mezzanine interface is 1000 Mbps (1000BASE-SX link established,
the Link LED is lights solid amber), you need to reconfigure the
network connected to the LAN mezzanine interface.
Introduction
Hitachi Compute Rack 220H CRU Replacement Guide
State
A 10GBASE-T link with a hub has been
Green-On
established.
A 1000BASE-T link with a hub has been
Amber-On*
established.
A link with a hub has not been established or
Off
device driver has not been loaded.
Green-On
A link with a hub has been established.
Green-Blink
Data is being transmitted or received.
A link with a hub has not been established or
Off
device driver has not been loaded.
Description