Maximum Speed; Minimum Speed - ABB ACS 600 Startup Manual

Check the rotation direction of the motor.
• Press ACT to get the status row visible.
• Increase the speed reference from zero to a small value
by pressing REF and then
• Press (Start) to start the motor.
• Check that the motor is running in the desired direction.
• Stop the motor by pressing
To change the rotation direction of the motor:
• Disconnect mains power from the ACx 600, and wait 5 minutes for the
intermediate circuit capacitors to discharge. Measure the voltage
between each input terminal (U1, V1 and W1) and earth with a
multimeter to ensure that the frequency converter is discharged.
• Exchange the position of two motor cable phase conductors at the
motor terminals or at the motor connection box.
• Verify your work by applying mains power and repeating the check as
described above.
6 – SPEED LIMITS AND ACCELERATION/DECELERATION TIMES
Set the minimum speed. The general parameter setting
procedure is given on Page 2.
Set the maximum speed. The general parameter setting
procedure is given on Page 2.
Set the acceleration time 1. The general parameter setting
procedure is given on Page 2.
Note: Check also acceleration time 2, if two acceleration
times will be used in the application.
Set the deceleration time 1. The general parameter setting
procedure is given on Page 2.
Note: Set also deceleration time 2, if two deceleration
times will be used in the application.
Standard Application Program
START-UP PROCEDURE
5 – ROTATION DIRECTION OF THE MOTOR
or (
.
1
FREQ
CURRENT
POWER
or ).
1
20 LIMITS

01 MINIMUM SPEED

[ ]
1
20 LIMITS

02 MAXIMUM SPEED

[ ]
1
22 ACCEL/DECEL
02 ACCELER TIME 1
[ ]
1
22 ACCEL/DECEL
03 DECELER TIME 1
[ ]
Start-up Guide
L->[xxx] rpm
xxx Hz
xx A
xx %
forward
direction
reverse
direction
L-> 0.0 rpm
L-> 0.0 rpm
L-> 0.0 rpm
L-> 0.0 rpm
I
O
O
O
O
5