Using Accessories
Using an Optional Microphone
To use a long microphone such as the optional ECM-670/672, fit an optional CAC-12 Microphone Holder to the
camcorder, then mount the microphone in this holder.
Fitting the optional CAC-12 Microphone Holder
Remove the two retaining screws (M3 8) for the
optional microphone holder, then use these screws to
Fitting an optional microphone
Use the following procedure to attach an optional
ECM-670 Microphone.
Loosen the screw of the CAC-12
Microphone Holder, then open the
holder and replace the microphone
adaptor with the one supplied with
the ECM-670 Microphone.
Fitting optional microphones (operable with a
48 V supply) other than the ECM-670
Use the same fitting procedure as for the ECM-670,
but note the following differences with respect to the
microphone adaptor.
36
Chapter 2 Fitting and Connections
Screws removed from the
camcorder
CAC-12
attach the CAC-12 Microphone Holder.
Microphone adaptor
ECM-672: no microphone adaptor required.
Slender microphones (19 mm (
use the microphone adaptor supplied with the
CAC-12.
3
/
inch) diameter):
4