Connecting The Dsr-70/70P Digital Videocassette Recorder (Optional Dsbk-140 Is Required); Connecting An External Vcr - Sony 500WSPL Operating Instructions Manual

Connecting the DSR-70/70P Digital Videocassette Recorder (Optional
DSBK-140 Is Required)
You can do cut editing and digital dubbing when connecting the DSR-70/70P with fitting the optional DSBK-140,
using an i.LINK cable (DV connecting cable).
DSR-500WSL/500WSPL
Notes
• The camcorder does not support the noiseless
function of the various speed playback.
• The slow playback will be automatically released to
protect the tape if the slow playback lasts for about
one minute.

Connecting an External VCR

You can use a following external VCR connected to
the VTR connector (26-pin) or the DV OUT connector
for recording.
Connector
VCR
VTR connector
BVW-50/50P/35/
35P (portable)
VTR connector
VO-8800/6800
(U-matic)
DV OUT Digital
connector
Videocassette
Recorder DSR-
20/20P/70/70P/
2000/2000P, etc.
DV OUT
i.LINK cable (DV connecting cable)
• When dubbing tapes using the DSR-70/70P, a
Notes
• There is no power supply connection between the
• The VTR connector always outputs the signals from
Connecting cable
CCZ-A Camera
cable (max. length
10 m (33 ft.))
• When no VCR is connected to the VTR connector
CCZQ-A Camera
cable (max. length
10 m (33 ft.))
i.LINK cable (DV
connecting cable)
(max. length
4.5 m (14 ft.))
DSR-70/70P Digital
Videocassette Recorder
DV IN
continuous recorded section of approximately five
seconds is required before the recording start point. It
is recommended to record beforehand color bars or a
similar signal at the start point of the source tape to
be dubbed on this unit.
camcorder and VCR. Provide separate power
supplies.
the camera (impossible to output the playback video
of the internal VCR), and disallows the CCU
connection.
(26-pin), it does not supply signals.
Chapter 2 Fitting and Connections
45