Technical Reference; Performing Network-Wide Remote Diagnostics - GE MDS SD Series Technical Manual

MDS 05-4846A01, Rev. D
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8461-MDS-UP-SD9-MS2ES-Upgrade-Key-SD9-MS-to-SD9-ES.aspx

8.0 TECHNICAL REFERENCE

8.1 Performing Network-Wide Remote Diagnostics

Diagnostics data from a remote radio can be obtained by connecting a
laptop or personal computer running GE MDS diagnostic software, such
as MDS PulseNET or MDS InSite to any radio in the network. Figure 28
shows a sample arrangement for performing network-wide remote diag-
nostics.
DTYPE
NODE
RTU
DTYPE
ROOT
MASTER STATION
DIAGNOSTICS DATA
(TO NMS APPLICATION)
Figure 28. Network-Wide Remote Diagnostics Setup
NOTE: This section of the manual assumes that the radio's Ethernet
port is being used for diagnostic configuration. This is the
preferred/recommended method to use. Alternatively, the
COM1 port may be used. See the SD Serial/Telnet Manage-
ment Supplement, Part No. 05-6193A01 more information.
SD Series Technical Manual
DTYPE
RTU
NODE
RTU
TO DATA PORT
(DB-25)
TO DIAGNOSTICS
PORT (DB-9)
PAYLOAD DATA
(TO SCADA APPLICATION)
HOST COMPUTER
DTYPE
NODE
75