Bosch e-GoKart PowerTrain Young Star Manual page 56

6 | Wiring Harness instruction / Build up chassis
56 / 60
Illustration 66: Sensor turned in the final counter clockwise position
After the sensor is fixed, you should check the sensor position.
For the calibration, please use the BOSCH MOTORSPORT calibration adapter.
The following picture shows the needed parts:
Illustration 67: Multimeter with calibration adapter
Please connect the calibration wiring harness with the digital multimeter.
– GND (blue) connector in COM
– Sig. 1 (green) connector in „V"
– USB connector with a Laptop (5 V supply)
– Acceleration pedal connector with the acceleration sensor
Acceleration Pedal Position
0 %
100 %
Table 1: Calibration Values
e-GoKart_Powertrain__Young_Star__Manual
Sensor Signal
1,700 to 1,730 mV
2,850 to 2,900 mV
Bosch Motorsport