Chapter 3 Fujitsu 3.2 Tb Flash Accelerator Card Settings; Checking The Fujitsu 3.2 Tb Flash Accelerator Card; Optimizing The Fujitsu 3.2 Tb Flash Accelerator Card - Fujitsu 7119601 User Manual

Chapter 3 Fujitsu 3.2 TB Flash Accelerator Card Settings
3.2 Optimizing the Fujitsu 3.2 TB Flash Accelerator Card
Chapter 3 Fujitsu 3.2 TB Flash Accelerator
This chapter describes how to configure the Fujitsu 3.2 TB Flash Accelerator Card.
3.1 Checking the Fujitsu 3.2 TB Flash Accelerator
Card
You can check the Fujitsu 3.2 TB Flash Accelerator Card in the same way as detecting a hard disk drive.
The command shown below is an example.
# /usr/sbin/format
Searching for disks...done
AVAILABLE DISK SELECTIONS:
:
2. c9t1d0 <SAMSUNG-MZPLL3T2HMLS-000-GPNA-2.91TB>
/pci@8300/pci@4/pci@0/pci@1/nvme@0/disk@1
/dev/chassis/SYS/PCI#2/NVME/disk
Specify disk (enter its number):
3.2 Optimizing the Fujitsu 3.2 TB Flash Accelerator
Card
To obtain optimal performance, arrange all partitions to start on a 4 KB boundary.
In the following command example, the first sector of the partition is not aligned on a 4 KB boundary (1
sector = 512 bytes).
partition> print
Current partition table (original):
Total disk sectors available: 6251217517 + 16384 (reserved sectors)
Part Tag
0 usr
1 unassigned
2 unassigned
3 unassigned
4 unassigned
5 unassigned
Card Settings
Flag First Sector
wm
wm
wm
wm
wm
wm
Size
34
2.91TB
0 0
0 0
0 0
0 0
0 0
6
Last Sector
6251217550
0
0
0
0
0
C120-0067-02EN