Page 3
CPU Operation and onboard I/O status Run / Stop Switch Control CPU operation Ethernet CPU (In selected models) With RJ45 Port COM1 Online access, Modbus RTU master/slave, CS31-Bus master, ACSII Integrated onboard I/O Convenient cost effective solution ABB Automation products | 3...
Page 12
By default ABB Automation products | 12...
Page 13
If Internet access is existing CBP shows by default ABB homepage ABB Automation products | 13...
Page 14
2 child tabs. The 1 tab is IO configuration, Click on the 2 tab for IO Mapping To create IO variable for the CPU, go to expand OBIO and then double click on the IO (Onboard IOs) selection ABB Automation products | 14...
Page 15
Click on I/O mapping tab Click to expand. Click to expand. Double click on the cell and give the name of the IOs as shown. Double click on the cell and give the name of the IOs as shown. ABB Automation products | 15...
Page 26
Key in your desired IP address and subnet mask then click “OK” Select Local Area Connection Select “Internet Protocol Choose “Properties” Version 4 (TCP/IPv4)” ABB Automation products | 26...
Page 27
Activate “Force IP settings” Enter now the new IP address, subnet mask and standard gateway here ABB Automation products | 27...
Page 29
Select “New” Define a name for the connection Select driver “TCP/IP” then click “OK” Enter the new parameters: IP address: xx.xx.xx.xx Port: 1201 Motorola byte order: Yes Then press “ENTER” and “OK” ABB Automation products | 29...
Page 30
Click on “Control Panel” Click on Windows Start Button ABB Automation products | 30...
Page 32
Choose “Communication Parameters” Select “Gateway” Choose “Local” Click “New” Define a name for the connection Select driver “Serial” then click “OK” ABB Automation products | 32...
Page 33
Enter the new parameters: Port: COM number in PC Baudrate: 19200 Parity: No Stop bits: 1 Motorola byte order: Yes Flow Control: Off Then press “ENTER” and “OK” Select “Online” ABB Automation products | 33...
Page 35
Double click on the FALSE state, you will see a blue indication of “TRUE” on the right. This information indicates that you want to set the value to TRUE. ABB Automation products | 35...
Page 41
To put the variable, put your cursor in the blank and press F2 ABB Automation products | 41...
Page 42
Similarly, press F2 to bring up the Input Assistant ABB Automation products | 42...
Page 43
Click icon To bring up the Input Assistant, put your cursor in the blank and press F2, then choose the desired variables from the list. ABB Automation products | 43...