Alarm 8022; General Restrictions; Functional Improvements From Version 06.05.11.00 To Version 06.05.24.00; Nck Increment 51.08.00 - Siemens Sinumerik 810D Start-Up And Upgrade Manual

M5 Setpoint display on HMI "0" rpm
$MN_DISPLAY_FUNCTION_MASK, bit 1=1
When the spindle is at zero speed, set speed "100" is displayed.
Example:
M3 S100
g4 F2
M5 Setpoint display on HMI "100" rpm
3.4

Alarm 8022

Depending on the machine data settings, alarm 8022 may be output.
Remedy: increase MD19250 by "1".
4

General Restrictions

- Software version 06.05.25.00 has not been released for ShopTurn. Software version 06.05.26.00 must
be used.
- The Continuous Dressing function is not enabled in software version 06.05.25.00. Software version
06.05.26.00 must be used for this.
- If Step7 Version 5.3 is being used, the toolbox must be installed if projects (including PLC blocks)
containing hardware components of the toolbox are to be processed.
- NCU *.4 with PLC 314C:
If master/slave configurations are used, the PLC 314C must not be operated as a slave.
If such a configuration is required it must be implemented with a CP module.
- Function G643 (approximate positioning in block) is enabled for applications in the tool change area (e.g.
optimizations for approaching the tool change position).
It is not enabled for applications in the machining process.
- The functions FCUB and FLIN in combination with the compressor COMPCAD are not enabled.
- NCUs nnn.3: The PCU 50 can only be shut down with the Exit button in emergency stop mode if PLC
firmware version < 12.30.10 is used.
- NCUs nnn.4 : The PCU 50 can only be shut down with the Exit button in emergency stop mode if PLC
firmware version < 10.60.17 is used.
- With the NCU 573.3, it is no longer possible to enable 10 channels and 31 axes at the same time.
That number is now limited to eight channels.
- The number of channels is limited to 6 for NCU 572.3 / 572.4, 31-axis software.
The number of axes including the DMP block is limited to 31. If, for example, a DMP block is used with
31-axis software, at total of 30 axes are still possible.
5

Functional Improvements from Version 06.05.11.00 to Version 06.05.24.00

5.1

NCK increment 51.08.00

BRKdb06987 BRKdb08506
BRKdb08873 BRKdb08884
© Siemens AG 2004. All rights reserved
BRKdb08596 BRKdb08769
CHMdc08516 CHMdc08557
Page 6 of 8
BRKdb08786
ERLde59971
SINUMERIK 810/840D Upgrade Guide
BRKdb08840
ERLde60083
2004-12-07