Dell CMC Technical Specification page 2

Component
Server Module BIOS
™
PowerEdge M600/M605 LAN on
motherboard (LOM)
iDRAC
CMC
To ensure proper deployment of the FlexAddress feature, update the BIOS and
the firmware in the following order:
1 Update all mezzanine card firmware and BIOS.
2 Update server module BIOS.
3 Update iDRAC firmware on the server module.
4 Update all CMC firmware in the chassis; if redundant CMCs are present,
ensure both are updated.
5 Insert the SD card into the passive module for a redundant CMC module
system or into the single CMC module for a non-redundant system.
Installing the FlexAddress SD card in the CMC
For a redundant CMC module system, install the FlexAddress SD card on the
passive module. On the passive module, the solid blue LED is not active.
NOTE:
The contents of the SD card are stored in the LCD control panel. CMC replacement
does not require reinstallation of the SD card.
NOTA:
Before installing the SD card into the CMC module, verify the write-protection latch is
in the "unlock" position. The FlexAddress feature cannot be activated if the SD card is write
protected.
1 Press in the CMC release latch on the handle and rotate the handle away from
the module front panel. Slide the CMC module out of the enclosure.
NOTE:
Electrostatic discharge (ESD) events can harm electronic components inside your
equipment. Under certain conditions, ESD may build up on your body or an object, and then
discharge into another object, such as your CMC. To prevent ESD damage, you should
discharge static electricity from your body before you interact with any of your equipment's
internal electronic components.
Minimum required version
™
(PowerEdge M600) BIOS 2.02 or later
™
(PowerEdge M605) BIOS 2.03 or later
Boot code firmware 4.4.1 or later
iSCSI boot firmware 2.7.11 or later
Version 1.11 or later
Version 1.10 or later