4) Press-fit drive gear bearings (right (2) and left (3)) to reduc-
tion drive gear (1).
Apply gear oil to ball of bearing.
5) Install reduction drive gear assembly (2) and reduction
driven gear assembly (3) to left case (1).
Transfer assembly
ASSEMBLY
CAUTION:
Clean mating surfaces of cases with solvent completely,
otherwise oil leakage might take place.
1) Clean mating surface of right case and left case (1), and
apply sealant to left case (1) by using a nozzle as shown in
figure by such amount that its section is 1.5 mm (0.059 in.) in
diameter.
"A" : Sealant 99000-31230
2) Tighten transfer case bolts to specified torque.
Tightening torque
Transfer case bolts (a) : 23 N·m (2.3 kg-m, 17.0 lb-ft)
TRANSFER 7D-19