Connections For A Super-Motion Camera (With The Bkp-9330) - Sony CCU-900 Operation Manual

Connections for a Super-Motion Camera (with the BKP-9330)

Other than the optical-fiber cables, all cables are 75-ohm coaxial cables with BNC connectors.
BVP-9500WS/9500WSP
CCU-900/900P + BKP-9330
CA-950/950P
Optical-fiber cable
Operation mode of the BVP-9500WS/9500WSP, normal speed (×1) or
triple speed (×3), can be selected via the INCOM REMOTE connector on
the rear panel. To select the operation mode on the CCU-900/900P, set the
signal level at pin 23 of the INCOM REMOTE connector to L. Then the
operation mode, normal or triple, can be selected via pin 20 of the INCOM
REMOTE connector as shown in the table below. In this case, the
selection is enabled on the CCU only.
INCOM REMOTE
pin 20 (×1/×3)
H (open)
L
SS-A SS-B SS-C
MAV-555
+
BKMA-520SS
Operation mode of the
BVP-9500WS/9500WSP
×1
×3
••••
• • •
••
••
• ••••••
RCP-700-series
Remote Control
Panel
21