Connections For Control, Intercom, Tally, And Audio Signals - Sony CCU-900 Operation Manual

Connections

Connections for Control, Intercom, Tally, and Audio Signals

22
An configuration example is shown in the figure on the next page.
Selecting a waveform monitor
The waveform monitor to be connected to the D-sub 15-pin WF MODE
connector of the CCU-900/900P or to the WF MODE connector on the
CNU-700 Camera Command Network Unit is a recall type monitor. With
a recall-type monitor, the desired display mode can first be set up on the
waveform monitor (preset), and the mode can then be selected externally
(recall) with the monitor select buttons on the MSU-700A/750 or on the
RCP-700-series unit.
The display mode and the monitor select button have the following
relations:
Display mode Monitor select buttons
PRESET 1
PRESET 2
PRESET 3
PRESET 4
PRESET 5
PRESET 6
PRESET 7
PRESET 8
Using DVS-V1201 SD Digital Video Routing Switchers in a
cascade configuration
Set REMOTE 2 unit address switch "5" of the DVS-V1201 SD Digital
Video Routing Switcher to ON and all others to OFF. When connecting
DVS-V1201 SD Digital Video Routing Switchers in a cascade
configuration to be used with 13 or more cameras, set unit address switch
"6" of the second unit to ON and the others to OFF.
R
G
B
SEQ or R + G + B
ENC
R + B
R + G
G + B