Getting Started; Unpacking; Hooking Up The System - Sony RXD-700 Operating Instructions Manual

Sony cd receiver operating instructions
Hide thumbs Also See for RXD-700:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Getting Started

Getting Started

Unpacking

Check that you received the following items:
• Remote commander (remote) (1)
• R6 (size AA) batteries (2)
• AM loop aerial (1)
Inserting batteries into the remote
You can control the CD Receiver using the supplied
remote.
Insert two R6 (size AA) batteries by matching the +
and – on the batteries. When using the remote, point it
at the remote sensor g on the CD Receiver.
When to replace batteries
With normal use, the batteries should last for about six
months. When the remote no longer operates the CD
Receiver, replace both batteries with new ones.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
• If you do not use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
EN
4

Hooking Up the System

Overview
This section describes how to connect your speakers,
tape deck, FM aerial and the supplied AM loop aerial
to the CD Receiver. Be sure to turn off the power of
each component before making the connections.
SPEAKERS A
TAPE
AM ANTENNA
+
+
+
+
SPEAKERS B
FM ANTENNA
Speaker system hookups
You can connect two pairs of speakers, A and B.
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
(+)
(–)
Twist the stripped ends of the cord about 15 mm (about 2/3
inch). Be sure to match the speaker cord to the appropriate
terminal on the components: + to + and – to –. If the cords
are reversed, the sound will be distorted and will lack bass.
}
]
Connecting to bi-wire system speakers
Since the two pairs of speaker terminals on your CD
Receiver, SPEAKERS A and B, can provide
simultaneous speaker output, you can use them to
connect a bi-wire speaker system.
To select speaker system A or B
Press SPEAKER A or B. To drive both speaker systems
simultaneously, press both SPEAKER A and B.
Note
Use speakers with a nominal impedance of 4 to 16 ohms.
When outputting at the same time to two speaker systems,
use speakers with a nominal impedance of 8 to 16 ohms.
To mains
(+)
(–)
}
]

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents