Table of Contents
Advertisement
5.14 Removable fan
The CliniScape has an active cooling, so it carries an IP21 grade fan in a fan box that is totally separated from the
rest of the electronics. Liquid and dust can enter into the in vent and out vent slots without jeopardizing the
correct operation of your units. The only undesired consequence is that the fan can get dirty and that the holder
could be subject to infection control.
In order to eliminate any possible cause of infection, the fan and the box can be cleaned, with the first that can
be even replaced.
WARNING: You must shut down the system before removing the fan. As further
precaution, besides switching off and disconnecting the power adaptor, you should remove
the battery too and do not operate the fan cleaning on the powered docking station.
Replacing the fan is easy and immediate.
In the figure here aside you can notice that there is a small
snap in the middle of the first slot of the grid.
With the tool provided with the CliniScape, you have to
push this snap as shown in the illustrations below.
The fan will pop up and then it can be slided out from the
top
When re-inserting it after cleaning or its replaceable unit,
push it until you hear the click of the snap and the outer part
of the fan shows no gap with respect to the CliniScape
profile.
39
Advertisement
Table of Contents
