Connections For Cut Editing Using Sdi Interface (Optional Dsbk-160 Required); Settings Required When Connecting An External Editing Control Unit; Timecode Settings On This Unit - Sony DSR-70 Operating Instructions Manual

Connections for Cut Editing Using SDI Interface
(Optional DSBK-160 Required)
For a cut editing system using this unit together with a
DNW-A25/A25P Betacam SX VCR using an SDI
connection, the following figure shows an example of
the connections. In this example, the DNW-A25/A25P
is used as the recorder and this unit is used as the
player.
DNW-A25/A25P (recorder)
REF. VIDEO IN
SDI IN
Settings on the DNW-A25/A25P
Switch/menu
REMOTE/LOCAL
REF. VIDEO IN 75
termination switch
Settings Required When Connecting an External
Editing Control Unit
When connecting an external editing control unit to
this unit and using this unit as a recorder, make the
following timecode settings on this unit and VCR
constant and DIP switch settings on the editing control
unit.
REMOTE
(These cables are included in the optional BKNW-225 Docking Kit.)
Setting
LOCAL
OFF
Note
In this case, the DSBK-160 SDI Iuput/Output Board is
required.
DSR-70/70P (player)
1
2
REMOTE
1
1 75
coaxial cable (not supplied)
2 RCC-5G/10G/30G 9-pin remote control
cable (length 5 m (16 ft)/10 m (33 ft)/30
m (98 ft), not supplied)
Settings on the DSR-70/70P
Switch
REMOTE/LOCAL

Timecode Settings on This Unit

Make the following timecode settings for this unit.
Switch/sub LCD menu
TC INT/EXT switch
Sub LCD menu
PRESET/REGEN item
(General settings page (1))
Sub LCD menu
F-RUN/R-RUN item
(General settings page (1))
Chapter 8 Connections and Settings
REF. VIDEO OUT
SDI OUT
Setting
REMOTE
Setting
INT
PRESET
F-RUN
115