Sony DSR-70 Operating Instructions Manual page 83

4
While watching the LCD monitor display, when
you wish to switch the display, hold down the +/
MARK button and press the –/LIST button.
The display on the LCD monitor as well as the
picture being recorded is switched.
5
To stop recording, press the STOP button.
Recording stops.
To adjust the output video signal phases
When long cables are used to connect two cameras to
this unit, a slight shift in phase between the video
signals input from the two cameras may result. When
the phase shift is of a significant magnitude, you can
detect it as a picture discontinuity on the LCD monitor
at the switch between the signals from the two
cameras.
To align the phases of the video signals from the two
cameras, adjust the phase of the output video signal
from one of the two cameras as follows.
REC INHI
OFF
ON
ASSEMBLE
AUDIO IN
DELETE
LCD monitor
2
1,5
TC CHARACTER
LOCAL INT ON MENU SET
2
REMOTE EXT OFF
INSERT
VIDEO AUDIO TC
CH1,1/2 CH2,3/4
– +
TRIM
CLIP
LIST MARK
LINK
ENTRY SHIFT
1
IN OUT
1
Holding down the ENTRY/SHIFT button, press
the MENU button.
The SYSTEM MENU screen appears on the LCD
monitor.
SYSTEM MENU
VIDEO PHASE CHECK
2
Using the jog/shuttle dial, select the VIDEO
PHASE CHECK item on the SYSTEM MENU
screen, then press the SET button.
The pictures from the two cameras are alternately
displayed on the LCD monitor (switched 30 times
per second (DSR-70)/24 times per second (DSR-
70P)).
3
If the text displayed on the LCD monitor jitters,
adjust the H PHASE (horizontal phase) of one of
the two cameras until the text stops jittering.
(Luminance signal phase adjustment)
Chapter 5 Special Editing and Recording/Playback
(Continued)
83