Table of Contents
Advertisement
4. Setting Up the Channel
List - Initial Setup
After you finish connecting
your TV. you need to run Initial Setup,
which autolnatically
sets up available
channels.
The Initial Setup screen appears
when you turn on your TV for the first time. If you do not want to
set up the channels
at this time, you can do it later by selecting
the Auto
Program
option
in the Channel
menu (see page 30).
POWER
1
Press @
to turn on the TV.
The Initial Setup
screen appears.
2
Press ,i,/,!, to highlight
the desired
language,
then press @.
3
The message
"First
please
connect
cable
or antenna"
and "Start
auto program
now?" appears,
make sure you aheady
connected
Cable or Antenna,
then select Yes
to start Auto Program.
If you want to start
Auto Program
later press No.
• If yon have Cable and Antenna
available, please connect Cable first.
4
The scanning
of channels
will start. If you
want to stop and run Auto Program
later
press Cancel.
5
When Auto
Program
is complete, press @
to continue
If the Initial Setup programming found
Cable channels, you will be able to scan
Antenna channels as well. Connect the
Antenna, you can use an A-B RF switch (not
supplied) and change the switch to Antenna,
then start Auto Program to search antenna
channels. If the Initial Setup programming
found Antenna
channels,
the Auto
Program process will finish. If you want to
scan Cable channels,
you can do it later
using the Channel menu (see page 30).
To run Auto Program again at a later time
[]
Use the Auto
Program
feature as described
on page 30.
To Display the Picture in your Preferred Aspect Ratio
[]
Select the proper Wide Mode as described
on pages 23 and 29.
• You may want to set up convenient features such as Favorites
(see page 26), Show/Hide
Channels
(see page 30), Label Channels
(see page 30) when Auto Program is completed.
20
Advertisement
Table of Contents
